19" Rack Monitors
Our 19" rack-monitors contain 2 parts, the standard chassis-monitor and a perfectly adapted 19" front plate. The monitor specification is available by clicking on "model - data sheet" and the drawing for the front plate (dimensioning, boreholes) can be found below (PDF).
Information for the touchscreen driver software can be found at the bottom of this site.
With antireflective protection glass
Diagonal cm / inch | HU | Model - Data sheet / Monitor | Brightness cd/m² | Resulution | Angle hor. / vert. | Dimensions (mm) |
---|---|---|---|---|---|---|
38/15,0 | 7 | 250 | 1024x768 | 160/140 | 482,6x310,35x30,5 | |
38/15,0 | 7 | DT-M150X11-Rack-7HE | 500 | 1024x768 | 178/178 | 482,6x310,35x30,5 |
48/19,0 | 8 | 350 | 1280x1024 | 170/160 | 482,6x354,8x34,3 | |
38/15,0 | 7 | 400 | 1024x768 | 160/140 | 482,6x310,35x30,5 | |
43/17,0 | 8 | 350 | 1280x1024 | 170/160 | 482,6x354,8x34,3 | |
48/19,0 | 8 | 300 | 1280x1024 | 178/178 | 482,6x354,8x34,3 |
With 5-wire resistive touchscreen
Diagonal cm / inch | HU | Model - Data sheet / Monitor | Brightness cd/m² | Resolution | Angle hor. / vert. | Dimensions (mm) |
---|---|---|---|---|---|---|
38/15,0 | 7 | 320 | 1024x768 | 160/140 | 482,6x310,35x31 | |
43/17,0 | 8 | 280 | 1280x1024 | 170/160 | 482,6x354,8x34,8 | |
48/19,0 | 8 | 280 | 1280x1024 | 170/160 | 482,6x354,8x34,8 | |
With PCAP touchscreen (Multitouch 5-Finger)
Diagonal cm / inch | HU | Model - Data sheet / Monitor | Brightness cd/m² | Resolution | Angle hor. / vert. | Dimensions (mm) |
---|---|---|---|---|---|---|
38/15,0 | 7 | 360 | 1024x768 | 160/140 | 482,6x310,35x42 | |
43/17,0 | 8 | 315 | 1280x1024 | 170/160 | 482,6x354,8x42 | |
48/19,0 | 9 | 315 | 1280x1024 | 170/160 | 482,6x400,05x42 | |
Touch-Driver-Software for Touchscreen Rackmount Monitors
Suitable drivers for various operating systems can be found on AMT-Penmount. Please choose drivers for:
Panel PC with resistive touch: Controller / Penmount 6000 USB
Panel PC with PCAP touch: Controller / Penmount PCI USB
Please choose 32/64 bit and download and unpack the software. For resistive touch a 9-point calibration is needed after the installation.